Before & After Photos

The new homeowner had a 1915 stone foundation home, that was showing signs of water intrusion in the basement. The customer also mentioned that there was a sump pump in the basement, but the life of the motor had come to an end.

The long-term goal of this customer was to finish the basement, but if you know you have a water intrusion issue in the basement, your first step to finishing is taking care of the leaks. 

Knowing that water is entering in through the foundation walls, you need to stop that water from penetrating the foundation or redirect the water. Now if you don't want to excavate and waterproof from the exterior, which is not always a guaranteed correction, you'll want to redirect that water with the installation of our Cleanspace vapor barrier. Where to redirect the water to? This is where you would install our Waterguard perimeter drainage system ( Drytrak for those tight tricky spots or thick slabs like monolithic flooring). The Cleanspace will drain those leaking foundation walls, directly down into the Waterguard.

So at this point, water has leaked in through the foundation wall and the vapor barrier did its job and directed the moisture down to the perimeter drain, but it can not stay here, the point of a waterproofing system is to get water out of the basement, so it needs somewhere else to go. This is where we replaced their old non working sump pump with our TripleSafe sump pump which collects the water from the waterguard and then discharges it on the exterior of the home.

Now finally having a warranted, dry basement, the homeowner can move on to the finishing portion and making this area in to a useable space!

The extremely high moisture levels in this customer's crawlspace had caused significant damage to the center support beam. Here we used existing piers and temporary jacks to lift the floor off the old cracked and rotting beam so we could replace it with new, pressure-treated lumber. Once we replaced the beam, we advised this customer to have a sump system and dehumidifier installed in order to keep the high moisture levels in check.

For a homeowner from Parkesburg, PA, a troubling vertical crack running from floor to ceiling signaled a call for help. Previous DIY attempts had only worsened the situation. That's where we stepped in. Utilizing our effective FlexiSpan system, we ensured a durable, tight seal against water intrusion.

This customer had an existing sump pump but was looking to upgrade. We came out and installed a Super SumpPump with a Battery Backup. 

This customer's crawlspace was wet, moldy and in dire need of attention. We started here by removing the old insulation and doing a full mold remediation. Nextt we added Silverglo insulated wall panels around the perimeter of the crawlspace. We then installed our Cleanspace drainage matting and Cleanspace liner which will provide a barrier against moisture and water intrusion. We also installed a Supersump sump pump system, this system come with a liner, a cast iron pump, a pump stand and an airtight lid with a built-in floor drain and WaterWatch alarm system. Lastly, we installed a Sanidry Sedona dehumidifier to check the humidity levels in check.