Before & After Photos

This homeowner was looking at options to replace or upgrade the insulation in their crawl space. We reviewed all of their options and they determined they wanted to encapsulate the space.

This Saluda basement had major water issues in the basement. The WaterGuard Drainage System and SuperSump were installed to help keep this basement dry ALL the time. 

As part of a basement waterproofing solution, we install a CleanSpace vapor barrier on the basement walls. The liner is sealed at all seams and mechanically attached to the walls. It directs the water that seeps through the foundation walls down into the WaterGuard drainage track and ultimately to the sump pump and away from the home's foundation. 

Water has been seeping into this basement through the porous block wall and damaging the fished wall and trim that had been installed on top of it. The sheetrock and trim have been cut away to expose the block wall where we can see water staining and efflorescence, clear signs of prolonged water infiltration. 

We installed WaterGuard, a perimeter french drain system that collects the infiltrating water and directs it to a sump pump where it is pumped away from the home's foundation. CleanSpace Vapor Barrier is installed on the foundation walls, about 6 inches above outside grade to direct the moisture coming through the walls down into the drainage system. This also allows the homeowners to refinish the basement without concerns of water damaging the walls again. 

This homeowner needed a new sump pump installed as part of a basement waterproofing system. Their old one was an open pit, that allowed odors and moisture to rise into the basement and be pulled up into the living space. 

Their new pump is a large basin that houses a 1/3hp pump covered with an air-tight lid. The system has a float on top allowing for water to enter if a leak occurs from above, and the basin is large enough that if the homeowner later feels a need to add a pump or battery backup system, they can do so without having to re-dig the hole or replace the basin. A clean pump stand keeps the sump out of any grime, grit, and sediment that may collect in the bottom of the basin to prevent clogs.